iPhone 7 Plus Display Assembly Repair
iPhone 7 Plus Display Assembly (LCD and Digitizer/Front Panel) Repair Guide
Find affordable iPhone 7 Plus replacement screens and parts here.
Power down your Apple iPhone 7 Plus smartphone.
Eject the Nano-SIM Card Tray.
Step 3 (iPhone 7 Plus Display Assembly)
Remove the two bottom 3.4 mm Pentalobe screws located next to the lightning connector.
Use the precision knife to create enough space to insert a triangle opening tool.
With the opening tool slice through the intense adhesive and help carefully decouple the iPhone 7 Plus display assembly from the rear case.
Unlike previous iPhone models the 7 Plus bizarrely opens to the side.
The display assembly is still connected to the iPhone by cables along the middle-right side, so don’t try to remove it entirely just yet.
Remove the following 4 Tri-Point screws securing the bracket that covers the battery connector and two of the display cables. These screws are different sizes, so be sure to remember where they go.
With the bracket out of the way spudge up the cables from the logic board.
Remove the following 3 Tri-Point screws that secure the bracket covering the upper component display cable.
Disconnect the cable and free the iPhone 7 Plus display assembly from the phone.
Step 5 (iPhone 7 Plus Front-Facing Camera Cable Assembly)
Remove the following 5 Phillips screws, followed by the metal clip they secure in place.
Easily extract the stereo-enabling speaker.
Use the tweezers to help remove the tangled up iPhone 7 Plus Front-Facing Camera Cable Assembly. It includes the front-facing camera, microphone, proximity sensor and ambient light sensor.
Step 6 (iPhone 7 Plus Solid State Home Button)
Remove the following 4 Tri-Point screws and then the metal bracket.
Separating the solid state iPhone 7 Plus home button is simple, with only light adhesive on the cable and no delicate gasket.
Step 7 (iPhone 7 Plus LCD Shield Plate)
Remove the following Phillips screw, and then the 5 Tri-Point screws.
With no adhesive on the iPhone 7 Plus LCD shield plate, and the cables nicely managed, simply lift it away from the display assembly.
* To reassemble your device, follow the steps in reverse order.