|
You will need the following tools to
help assist you in your Tungsten W Take Apart.
A
Torx T6 Driver
A fine flat head screwdriver or shim tool
Remove Stylus and SD Memory Card |
|
Flip over the unit and remove the 4
screws (circled in red) using the
Torx T6 Driver. |
|
Using your shim tool (or fine flat head
screwdriver) you will need to release two tabs. keep
seperation pressue on the unit edge as your are trying to release
the tabs. |
|
This picture shows the unit open.
You can see the two tabs on the upper edge of the case. |
|
This shows the unit seperated from the
back side. Using the unit mainboard (pictured left)
|
|
You will be separating the screen from
this mainboard by releasing two more tabs as seen on the bottom edge
piece using your shim tool or flathead screwdriver. |
|
Once you have the unit open you should
be able to see and remove the battery from the unit. |
|
This picture shows the battery removed
next to the unit. |
|
Tiy can now open the unit further and
will need to remove the connector to the screen. |
|
Addtionally you can also remove the
other side of the cable connected to the unit motherboard. |
|
This picture shows the connector
disconnected from the screen |
|
This shows the unit mb seperated from
the screen and case. |
|
This shows the screen seperated from the
front cover display. you now can access the button templates |
|
This shows the screen removed with the
button template connectors disconnected to the side.
To complete this fix - work in reverse
to re-assemble your unit. |
